Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RME - Software Mgmt X SNMP RW

Hi,

I was trying to add an Cisco Software Image to CWLMS (RME) software repository (on Device Center > Management Tasks > Add Images to Software Repository). Then I got the error showed on attached image. I don't have SNMP RW community configured on CWLMS for this device because it is not allowed to enable on customer network.

So, my question is: is it necessary to configure SNMP RW community to take devices' software image to RME software repository?

Thank you.

Best Regards.

Flaviano.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: RME - Software Mgmt X SNMP RW

Yes, it is necessary. The sync will be done using an SNMP-triggered operation on the CISCO-FLASH-MIB.

1 REPLY
Cisco Employee

Re: RME - Software Mgmt X SNMP RW

Yes, it is necessary. The sync will be done using an SNMP-triggered operation on the CISCO-FLASH-MIB.

111
Views
0
Helpful
1
Replies