Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

RME Syslog doesn't receive devices coldstart

hello all,

I don't receive Coldstart from my device when there is a reboot in my RME Syslog report 24 hours...

1 REPLY
Cisco Employee

Re: RME Syslog doesn't receive devices coldstart

The message may not actually be sent out on the wire due to the underlying network not yet being initialized (i.e. spanning tree, route convergeance, etc.). Check your syslog_info (Solaris) or syslog.log (Windows) to see if the messages are actually making it to the server. If they are, then SyslogCollector and/or SyslogAnalyzer debugging may be required. If not, then they are most likely being generated before they can be encapsulated on the wire.

103
Views
0
Helpful
1
Replies
CreatePlease to create content