Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

RME syslog trunk_id

I get the following message in RME's syslog output:

"trunk_id 341 not found(domain Grn_EDM)"

The syslog message is from a 6509, which is a VTP client. The domain is valid.

My question: Where do if find the trunk id for valid trunks?

1 REPLY
Cisco Employee

Re: RME syslog trunk_id

This message indicates an intermediate error occurred and VTP pruning might or might

not work on that trunk; [dec]/[dec] is the trunk module number/port number, and (domain [chars]) is the domain name.

Enter the show trunk command to verify VTP pruning is working for that trunk.

If it is not working, disable and then enable the trunk port.

Note that the trunk ID is printed in HEX.

Please run the following "show port ifindex" command to display relation port-index and

find which port is assigned to index 341 (convert 341 to decimal).

111
Views
0
Helpful
1
Replies
CreatePlease to create content