I recently installed LMS206 on W2003. On of the first things is to archive the config. I am using TELNET to sync the config with no success when aaa is enabled with local authentication on the devices; when aaa new-model is removed, all succeeded. This might be the username/prompt issue. How can I solve this problem?
I also tried RCP. All failed with error: permission denied. The commands in the switch are as follows:
ip rcmd rcp-enable
ip rcmd remote-host xxxx 10.70.211.202 www enable
where xxxx is local username and www is owner in RME.
Check the DCR credentials under Common Services > Device and Credentials > Device Management for this device to resolve your telnet problem. Make sure that the correct username and password are entered there. If you use custom Username/Password prompts, add them to NMSROOT/objects/cmf/data/TacacsPrompts.ini.
As for RCP, check the username configured under Common Services > Server > Admin > System Preferences, and make sure "www" is the RCP username.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...