Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

rmon alarm creation failure - false OID?

Hi there,

I'm working hard to get the problem solved but I'm at a loss.

I try to set up an alarm for over threshold in the rttMonJitterStatsRTTMax so the command is i.e. "rmon alarm 1 rttMonJitterStatsRTTMax 5 abs r 10 1 f 5 2 owner config"

but I receive an "Alarm creation failure".

I also tried instead of MIB object name the OID (1.3.6.1.4.1.9.9.42.1.3.5.1.9).

1.3.6.1.4.1.9.9.42.1.3.5.1.9.

1.3.6.1.4.1.9.9.42.1.3.5.1.9.0

1.3.6.1.4.1.9.9.42.1.3.5.1.9.0.

.1.3.6.1.4.1.9.9.42.1.3.5.1.9

.1.3.6.1.4.1.9.9.42.1.3.5.1.9.0

rttMonJitterStatsEntry.9

etc...

I get either an alarm creation failure or an unknown object message.

http://cisco.com/en/US/tech/tk869/tk769/technologies_white_paper09186a00801b1a1e.shtml#rmonalarmevent

neither works...

Anyone can help?

2 REPLIES
Cisco Employee

Re: rmon alarm creation failure - false OID?

You need get the specific index value of rttMonJitterStatsRTTMax like shown in the example:

rttMonJitterStatsRTTMax.100.120518706

Can you walk the object to see what the specific value is? Then you can use this.

New Member

Re: rmon alarm creation failure - false OID?

Not really. I only know the snmpwalk method in CLI. But is there any other way I can get the value? Especially if you have console access?

314
Views
0
Helpful
2
Replies
CreatePlease to create content