I'm trying to setup RMON on an ATM circuit to do the following:
1) To alert the management system when the link utilization reaches 85%
2) To alert the management system when the link utilization drops below the 85% mark
I would prefer to achieve this by specifying a percentage as apposed manually calculating the 85% mark in bits/second as the command can be rolled out to various sites which may have different link speeds.
Does anyone know the following:
1) What mib is required to achieve this?
2) What commands are required to achieve this. (excluding SNMP server commands)
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...