I have set timezone and the clock timing on my Router,after changing the clock time it shows me the updated timing just for 1 minute,after that it starts showing the timing as per the old settings only,i have attached the sh run and sh commands for ur reference,can anybody help me out.
Your post says that it is attaching the show run and the show clock output but what was attached was 2 copies of the show clock output. It would really help us sort out the issue if you would post the running configuration.
I agree with Didya that the symptoms sound like there is an NTP server configured from which you are learning time. If we could see the running config then we would know if this is the case.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...