Router down !Could not expand chunk pool for ipnat node. No memory availabl

T1success · ‎06-20-2006

Hallo all

My production ROUTER IS DOWN !Pls how can i bring it back soonest.

Your advise will be well appreciated .

Find below the output

"-Process= "IP Input", ipl= 0, pid= 47

-Traceback= 0x80681F68 0x8000A184 0x8000F714 0x800293F8 0x800285E4 0x8002AB48 0x

8002843C 0x80BE9A78 0x80BEAF00 0x80BEB890 0x80BEDFF8 0x80BE9374 0x80A322F0 0x80A

309F0 0x80A30CB8 0x80A30D3C

%SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ipnat node. No memory av

ailable

-Process= "Chunk Manager", ipl= 5, pid= 1

-Traceback= 0x80681F68 0x800282C4 0x8037AC44 0x8037E1F0

%SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ipnat node. No memory av

ailable

-Process= "Chunk Manager", ipl= 5, pid= 1

-Traceback= 0x80681F68 0x800282C4 0x8037AC44 0x8037E1F0

%SYS-2-CHUNKEXPANDFAIL: Could not expand chunk pool for ipnat node. No memory av

ailable

-Process= "Chunk Manager", ipl= 5, pid= 1

-Traceback= 0x80681F68 0x800282C4 0x8037AC44 0x8037E1F0

%SYS-2-MALLOCFAIL: Memory allocation of 65536 bytes failed from 0x800293F4, alig

nment 8

Pool: Processor Free: 1181156 Cause: Memory fragmentation

Alternate Pool: I/O Free: 34900 Cause: Not enough free memory"

Hints

Before the router went down today

erase nvram

followed by

reload

and

copying of a new configuration was done last week.Three differnt times.

Also ,one of the nat lines was edited today.Could this have caused the problem ?

I await your reply urgently.

Thanks

miheg · ‎06-20-2006

Something seems to make your router run out of memory.

Check if your router meets at least the minimum requirements for the IOS and if it is a real busy router I'd say double it.

Cheers,

Michel

T1success · ‎06-21-2006

Thanks.

How do i check the minimum requiremnts.

With the show commands?

miheg · ‎06-22-2006

With the type and version of IOS you can find on CCO what the requirments are.

You can also see if cisco has not withdrawn the image due to bugs.

show version on the router tells you what you have for IOS version, ram and flash.

Cheers,

Michel