You could use TCL and if you have 12.3 IOS (might be 12.4) you can run a kron to kick off the timer. You are going to have to work out the details on notification of failures, etc, because I am just learning EEM and TCL myself.
TCL: save this code as "ping_ip1.tcl" (or whatever you'd like, just make changes below to reflect the new filename). Once saved, load into flash, or onto a TFTP server. If you store anywhere other than flash, be sure to change the IOS kron line below (tclsh tftp/ftp/disk0/etc).
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...