I have four routers that are showing up in the DFM monitoring console as being "Unresponsive" with a reason of "No Services or ServiceAccessPoints on thsi System are responding". From my CiscoWorks server I can ping the routers, SNMP traps appear to be working from the routers since I can generate a "Cisco Configuration Management Trap" and have it display on the monitoring console. Not sure what DFM is trying to look for.......any help would be greatly appreciated...Thanks.
What version of DFM is this? While SNMP traps may be working, what about SNMP polling? Verify you can poll the same management IP for this device. You might also try putting a sniffer on the wire, then rediscover one of these routers in DFM, to see if the packet trace can shed more light on this problem.
Thanks for the response.....I believe I found the problem. All of these routers are frame relay routers with dial backup, we have loopback interfaces configured with "ip unnumbered loopback X" on the serial subinterface and dialer interface......the subinterface and loopback interfaces were not managed in DFM, I set both to manage and then rediscovered and all worked.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...