Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

run muliple commands at once?

I would like to check certain part of sh run configration of Cisco Ap.s . currently I am inter one by one to check sh run, I am wondering if I can run all together without writing a script. or if some one has a script and willing to share it. here my commands I am using now,

sh run | section channel ------>>

sh run | section include wlcp ----->>

sh run | section include wds ------>>

sh run | section include wnm ------->>

sh run | section include username  ------->>

Thanks in Advance.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: run muliple commands at once?

You could do this with two commands:

show run | section channel

show run | section include (wlcp|wds|wnm|username)

Or, try the one command:

show run | section (channel|wlcp|wds|wnm|username)
2 REPLIES
Cisco Employee

Re: run muliple commands at once?

You could do this with two commands:

show run | section channel

show run | section include (wlcp|wds|wnm|username)

Or, try the one command:

show run | section (channel|wlcp|wds|wnm|username)
New Member

Re: run muliple commands at once?

Thank you so much Mr. Clarke, this is exactly

I am looking for!!!

300
Views
0
Helpful
2
Replies