Problem: Ciscowokrs not able to get pull the running configuration for few of the nodes
Error Displayed beside the failed devices is
"Telnet :No telnet passowrds in RME databases Tftp:PGM_NMConfiguration Archive=6717Type=Unassigned message type::Timeout error, snmp operation failed,ssh,no username and password in ME database."
But I could do for more than 60 nodes,only five nodes is having this problem
SNMP,ICMP telnet TFTP is configured properly ,I can telnet in to network nodes from command prompt and also run SNMPwalk from command everything looks successful,All the nodes are tied with tacacus,I also added the tacacus username and password in the tacacus.ini.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...