Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SCH Transport Gateway

Hi Pro´s!

I ran into some problems installing the Transport Gateway for Cisco Smart Call Home. I downloaded the latest package for Windows and ran it on a Server 2003 SP2. The installation went on without any errors and I clicked on the Finish button and the application closed down. Now - when i press att the GUI icon och the desktop nothing happens!  I checked that the service was running, I stopped the service and turnt it on again, but nothing changed.
I´ve read the installation manual and it doesn´t mention anything special, just start the GUI and go on with the registration.

Has any of you any ideas what I should do?

Best regards

Johan

Everyone's tags (6)
1 REPLY
New Member

Re: SCH Transport Gateway

An update,

I found the answer in Troubleshooting and Support guide:
following steps:
Stop the TG service
Close the RDP Connections
Re-launch the RDP using the following command

mstsc /v /admin
Launch the Transport Gateway.


That, togheter with http://blogs.msdn.com/b/rds/archive/2007/12/17/changes-to-remote-administration-in-windows-server-2008.aspx where the complete solution.
Chers,
Johan

438
Views
0
Helpful
1
Replies