I am looking at installing SDM on our network. I am able to install the software on both the PC (Window XP SP2) and on the router (2610XM, 12.4(5a)) and configure the basics for the two to communicate. When I open the SDM Launcher and put in the IP address of the router, I get the login prompt as expected. Once I enter in the username/password, a new explorer window pops up with what I am assuming is an error. I am unable to actually get into the router. Please see the attached document for the error message I receive. Any help would be appreciated.
To fix this problem, you need to go to IE's Tools/Internet Options and click the Advanced tab, scroll down to Security section, and check "Allow active contents to run in files on My Computer". Then close IE and relaunch SDM.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...