Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Secondary credentials fail in CS

Hi everyone,

I have a question on a credential issue we encountered at a customer site during implementation of CWLMS 3.0.

Customer applied 2 sets credentials for initial discovery. As expected some of the devices were found but failed on the first credentials. But the secondary set seems not be tested if primary fails.

Is this corect behavior or are we interpreted default credentials wrong?

  • Network Management
3 REPLIES
Cisco Employee

Re: Secondary credentials fail in CS

Secondary credentials do not apply to Discovery. If you need to add multiple SNMP credentials for Discovery, you must do that within the Discovery settings.

New Member

Re: Secondary credentials fail in CS

Hi,

It's not about snmp credentials. It's about username/password/enable credentials. When first set (PRIMARY) fails, it should try the secondary.

/Jeroen

Cisco Employee

Re: Secondary credentials fail in CS

So you're talking about RME, then? If so, you must tell RME to use secondary credentials under RME > Admin > System Preferences > RME Secondary Credentials.

104
Views
0
Helpful
3
Replies
This widget could not be displayed.