Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Secondary IPs and SDM and Cisco Configurator Pro

It looks to me like SDM is not capable of adding a secondary IP address to an interface. Am I missing something? If I add a secondary IP address at the CLI I presume that SDM would become unaware of the secondary IP - correct?

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Secondary IPs and SDM and Cisco Configurator Pro

We can able to configure through CLI only

Follow this steps to configure the secondary network on the router using CLI.

conf t

int g0/0

ip address 10.227.220.1 255.255.255.0 secondary

end

GRE/IPSec enhancements-You can configure a secondary GRE tunnel, and add routing information to the GRE/IPSec configuration.

http://www.cisco.com/en/US/docs/routers/access/cisco_router_and_security_device_manager/software/release/notes/SDMrn11.html

1 REPLY
Silver

Re: Secondary IPs and SDM and Cisco Configurator Pro

We can able to configure through CLI only

Follow this steps to configure the secondary network on the router using CLI.

conf t

int g0/0

ip address 10.227.220.1 255.255.255.0 secondary

end

GRE/IPSec enhancements-You can configure a secondary GRE tunnel, and add routing information to the GRE/IPSec configuration.

http://www.cisco.com/en/US/docs/routers/access/cisco_router_and_security_device_manager/software/release/notes/SDMrn11.html

339
Views
0
Helpful
1
Replies
CreatePlease to create content