Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Seed Device Limit in Campus Manager (LMS 2.6)

Is there a maximum limit to the number of entries that can be added to the seed device file for device discovery in Campus Manager 4.0.9?

Ideally, I'd like to use the seed file from my NMS so that I have defined most of the devices to discover but it also gives scope to discover any that may have been missed - if I proceed with this, I'd be using a seed device file of 1064 devices.

Or does that sound a little too adventurous?

I'm upgrading from LMS 2.2 to 2.6 on new hardware and would prefer to re-discover the devices rather than a straight out import from the old system.

Thanks for any replies

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Seed Device Limit in Campus Manager (LMS 2.6)

Hi Claire,

maybe this link and the following five answers from jossy and questions from mermel

helps to clarify some things.

;-)

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.1dda9020/91#selected_message

Best regards,

Frank

2 REPLIES
Silver

Re: Seed Device Limit in Campus Manager (LMS 2.6)

Hi Claire,

maybe this link and the following five answers from jossy and questions from mermel

helps to clarify some things.

;-)

http://forum.cisco.com/eforum/servlet/NetProf?page=netprof&CommCmd=MB%3Fcmd%3Dpass_through%26location%3Doutline%40%5E1%40.1dda9020/91#selected_message

Best regards,

Frank

New Member

Re: Seed Device Limit in Campus Manager (LMS 2.6)

Hi Frank,

Thanks for your reply.

Great link, not only did it answer my question but jossy's explanation clarified things further.

I had searched earlier but didn't see that thread.

cheers,

Claire

141
Views
0
Helpful
2
Replies