Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

sending remote commands from cat6500?

I have 2 CAT6500 connected to each other with etherchannel. The issue I am facing is that all the vty sessions are used on one of them.. does anyone know a way to send commands from one CAT6500 to the other one. Both cores are up and running and doing what they're supposed to do.

Any ideas?

1 REPLY
Cisco Employee

Re: sending remote commands from cat6500?

At this point, you'll need to free up the vty lines from the switch's console. That is:

clear line TTY_NO

Alternatively, if you have SNMP read-write access to the switch, you can try clearing the lines using http://www.cisco.com/en/US/tech/tk648/tk362/technologies_problem_troubleshooting09186a00802b93ef.shtml .

109
Views
0
Helpful
1
Replies
CreatePlease to create content