Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

sensible value for Broadcast tresholds in DFM

Hi,

I'm looking for a sensible value for Broadcast and Utilisation tresholds in DFM. The defaults for utilization=40% and for broadcast=15%. It seems its possible to increasing this values (broadcast=40%, ultilization=75%).

Marita

2 REPLIES
New Member

Re: sensible value for Broadcast tresholds in DFM

Hai,

Yes it is possible in the following ways.

Go to DFm->Configuration -> Managing thresholds

In the right side from the DFM system defined groups select the Interface groups -> select your desired interface (serial or 1 Gb or 100 MB).

A separate window will open there it will display the default values. change your desired values 40% and 75% in broadcast and utilisation whatever u want.

Click save.

Hope this information helps you. if so pls rate it :)

Regards

New Member

Re: sensible value for Broadcast tresholds in DFM

Hi,

are these intelligent values? Or it's may be better to take the default thresholds. In our environment we have a average broadcast theshold from 20% Broadcast Messages by DFM.

Regards

120
Views
0
Helpful
2
Replies
CreatePlease to create content