Hello,
i have configured the following extended ip access-list on a router:
------------------------------------------
ip access-list extended TEST
remark TEST-REMARK
10 permit icmp any any echo-reply
15 permit icmp any any unreachable
25 permit icmp any any time-exceeded
---------------------------------------------
When i save the config and reload the router, the new sequence numbers are:
Extended IP access list TEST
10 permit icmp any any echo-reply
20 permit icmp any any unreachable
30 permit icmp any any time-exceeded
-------------------------------------------
So, the new sequence numbers are others than the configured one.
How can i make sure, that the sequence numbers are the same after a reload of the router?
Thanks
Regards,
Tobias
