Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Serial numbers on 3750 stacks

CW Contracts reporting reports the master SN. How can I pull all the SN for all devices in a 3750 stack for asset/inventory purposes?

  • Network Management
5 REPLIES

Re: Serial numbers on 3750 stacks

show version (on the master)

Silver

Re: Serial numbers on 3750 stacks

Yes, that is the best way but I want to add that you can actually check most of the commands for a stack member itself.

From the master:

remote command

Example:

C3750-Stack#remote command 2 show ver

C3750-Stack#remote command 2 shoe boot

Hall of Fame Super Gold

Re: Serial numbers on 3750 stacks

"sh ver" and look for "System serial number" line.

"sh inventory"

New Member

Re: Serial numbers on 3750 stacks

First, thanks to everyone that answered me, it feels effective when you get some kind of answer.

So, nothing in reports that can assist with inventory-ing serial numbers for equipment rather than loopback management.

I have built Netshow jobs that run sh ver | inc System serial and sh diag | inc PCB and in a large environment these are sloppy to parse.

I checked also Contract Status and these also just apply to the master serial.

Any other ideas?

New Member

Re: Serial numbers on 3750 stacks

kathegaj2 wrote:

First, thanks to everyone that answered me, it feels effective when you get some kind of answer.

So, nothing in reports that can assist with inventory-ing serial numbers for equipment rather than loopback management.

I have built Netshow jobs that run sh ver | inc System serial and sh diag | inc PCB and in a large environment these are sloppy to parse.

I checked also Contract Status and these also just apply to the master serial.

Any other ideas?

You need to create a Custom Report Template in RME Reports.

- Association : don't pick anything

- Inventory Group : Chassis

- Attribute : Chassis Serial Number

- Operator : Contains

- Value : All

Click "Add", then "Save Changes", then Finish.

Then you use your custom report on a selection of device (using Report Generator, Inventory, pick your custom template), and you should be good to go. I then export it to CSV for further editing, sorting, etc.

HTH.

Alex.

3832
Views
0
Helpful
5
Replies
This widget could not be displayed.