Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

set snmp trap enable syslog question #2 -

Ok. Now I understand this command will take the syslog messages and send them via SNMP to a mgmt server where the CISCO-SYSLOG-MIB is loaded and compiled.

Question: If the device is configured to log severity level 4,3,2,1 and 0, does this mean that only these messages (4,3,2,1,0)will be sent via snmp to the mgmt server or will everyting in the history buffer sent?

1 ACCEPTED SOLUTION

Accepted Solutions
Red

Re: set snmp trap enable syslog question #2 -

Only these syslog messages (4,3,2,1,0) will be sent as snmp traps.

1 REPLY
Red

Re: set snmp trap enable syslog question #2 -

Only these syslog messages (4,3,2,1,0) will be sent as snmp traps.

105
Views
0
Helpful
1
Replies
CreatePlease to create content