Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Setting HighUtilization Thresholds in CiscoWorks

I set my HighUtilization threshold in DFM to 75%, but I am still getting alerts at 6% on some of the devices please see screenprint.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Cisco Employee

Re: Setting HighUtilization Thresholds in CiscoWorks

Actually, the event is "correct." It is reporting the current utilization is 6.14 x 10^10 %. Clearly this is bogus. We have seen a lot of these problems in DFM. You should open a TAC service request for further troubleshooting. The developers at EMC need to get engaged as these events come from their code.

2 REPLIES
Highlighted
Cisco Employee

Re: Setting HighUtilization Thresholds in CiscoWorks

Actually, the event is "correct." It is reporting the current utilization is 6.14 x 10^10 %. Clearly this is bogus. We have seen a lot of these problems in DFM. You should open a TAC service request for further troubleshooting. The developers at EMC need to get engaged as these events come from their code.

New Member

Re: Setting HighUtilization Thresholds in CiscoWorks

Oh thanks for your help. I will open a TAC service request.

140
Views
0
Helpful
2
Replies
CreatePlease login to create content