Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Setting HighUtilization Thresholds in CiscoWorks

I set my HighUtilization threshold in DFM to 75%, but I am still getting alerts at 6% on some of the devices please see screenprint.

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Setting HighUtilization Thresholds in CiscoWorks

Actually, the event is "correct." It is reporting the current utilization is 6.14 x 10^10 %. Clearly this is bogus. We have seen a lot of these problems in DFM. You should open a TAC service request for further troubleshooting. The developers at EMC need to get engaged as these events come from their code.

2 REPLIES
Cisco Employee

Re: Setting HighUtilization Thresholds in CiscoWorks

Actually, the event is "correct." It is reporting the current utilization is 6.14 x 10^10 %. Clearly this is bogus. We have seen a lot of these problems in DFM. You should open a TAC service request for further troubleshooting. The developers at EMC need to get engaged as these events come from their code.

Highlighted
New Member

Re: Setting HighUtilization Thresholds in CiscoWorks

Oh thanks for your help. I will open a TAC service request.

143
Views
0
Helpful
2
Replies
CreatePlease to create content