Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Setting up NTP on an 857

Hi all,

I'm probably being thick here, but I cannot set an ntp server reference on my Cisco 857:

cisco#sh ver
Cisco IOS Software, C850 Software (C850-ADVSECURITYK9-M), Version 12.4(15)T5, RELEASE SOFTWARE (fc4)

...
cisco#ntp ?

% Unrecognized command


cisco#conf t

Enter configuration commands, one per line.  End with CNTL/Z.

cisco(config)#ntp ?
% Unrecognized command


What am I missing (apart from several hours sleep)?

Rich.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Setting up NTP on an 857

850 doesn't support NTP.  Try using "sntp server ".

If my post is helpful, may I request if you can rate it? Thank you very much.

1 REPLY
Hall of Fame Super Gold

Re: Setting up NTP on an 857

850 doesn't support NTP.  Try using "sntp server ".

If my post is helpful, may I request if you can rate it? Thank you very much.

1867
Views
0
Helpful
1
Replies
CreatePlease to create content