Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

Setting up RME Archive configs

I have a number of problems, but will do one at a time. To gain access to some devices, you use telnet and others ssh1. The telnet devices are OK, but the ssh1 devices are failing. Where do I tell RME which method to use? Version 4.05

1 REPLY
Cisco Employee

Re: Setting up RME Archive configs

It depends on what you're trying to do. For configuration jobs, the protocol order can be specified under RME > Admin > Config Mgmt > Transport Settings. For Software Management, this done under RME > Admin > Software Mgmt > View/Edit Preferences.

Note: SSH version is determined dynamically if the device supports SSH, and you wish to use SSH as a transport protocol. Both SSHv1 and v2 are supported.

115
Views
0
Helpful
1
Replies
CreatePlease to create content