Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

show acls on router

Does anyone know how to show multiple acl's that are configured on a router. I know how to run configure a show job and instead of doing a show access-list, I would like to show acls 7, 8 and 9. The documentation say to seperate each command with commas, which I did but when I click next, it does not go to the next screen. I can do a show access-list with no problems and start the job.

3 REPLIES
Cisco Employee

Re: show acls on router

Are you talking about using RME's Netshow feature? If so, what version of RME? How have you configured your Netshow job? Multiple custom commands separated by commas works fine for me in RME 4.2.

New Member

Re: show acls on router

Yes I am using RME's netshow feature. IT is RME 4.0.6. I am doing an adhoc job and you can put in multiple commands. I put in show access-l 7, show access-list 8, show access-l 9. Is this the correct syntax?

Cisco Employee

Re: show acls on router

The commands should be comma separated without any additional spaces. So:

show access-list 7,show access-list 8,show access-list 9

I tested that locally with RME 4.0.6, and it works.

729
Views
5
Helpful
3
Replies
CreatePlease to create content