show policy-map interface | Question about QOS show command output
I hope this is the correct place for this question. If not, please let me know.
When I issue the show policy-map interface command (in this case on a 3845) there is some output I don't understand. I have included some output below and formatted the lines I am confused about as "computer code" which show up as red on my screen. A list of the individual lines i'm confused about is below, followed by those liens in the context of the show policy-map command's output.
Any help with this will be greatly appreciated. Thanks in advance.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...