02-04-2008 03:26 AM
Hi guys, this could be a really simple fix but i cant seem to find the answer im looking for.
For some reason in the last week or so, when i do a "show run" command on my cisco PIX 515E instead of it just showing one page at a time and allowing me to either use enter/spacebar to scroll down through the config, it just displays the whole config in one go without stopping.
How can i stop this happening? It annoying becuase its a large config and in putty i am unable to see the settings towards the start of the config.
Can anyone shed some light?
Cheers
Simon
02-04-2008 04:33 AM
you need command
pager
ie pager 200 would allow 200 lines before the --more-- prompt
I use pager 24
M.
BTW you can increase scroll line buffer in putty (window --> lines of scrollback --> 200 is default that is not enough in most cases -- I use 2000)
Hope that helps rate if it does
02-04-2008 04:41 AM
Pager 24 is perfect
Thanks very much
Simon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: