Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

SMNP trap remove for 2 modules

I have removed 2 modules from my 6509 switch, 1 and 2.  How do I disable the ttraps for just those 2

mods without disabling it for all modules?

2 REPLIES
Cisco Employee

Re: SMNP trap remove for 2 modules

Are you trying to disable envmon or fru type traps or all traps related to these modules?

SNMP traps are usually global commands, which means they impact all modules/interfaces on a device. If the module isn't there, then traps won't be generated for it.

New Member

Re: SMNP trap remove for 2 modules

I think I got it.  The switch generated a trap

when the 2 mods were removed.  My net mon software (Spectrum) pick

ed it up after I removed from maintenance.  Must have been buffered in there.  You are quite correct.  It was only a global command.

Thanks!!

137
Views
0
Helpful
2
Replies
CreatePlease to create content