SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input on cisco WS-C3850-48P switch.
I have a 3850 switch which is not being polled in tool due to below snmp error. May I know is there any solution to get rid of it apart from the upgrade.
Jan 27 09:46:04.111: %SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input queue full Jan 27 09:46:04.113: %SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input queue full Jan 27 09:46:12.052: %SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input queue full
Model Number : WS-C3850-48P System Serial Number : FOC1920X0ZH
Switch Ports Model SW Version SW Image Mode ------ ----- ----- ---------- ---------- ---- 1 56 WS-C3850-48P 03.02.03.SE cat3k_caa-universalk9 INSTALL
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...