Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP command discussion

Hi,

Can some one help to clarify the difference between

snmp-server source-interface traps loopback 0

and

snmp-server trap-souce loopback 0 ?

Thanks.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: SNMP command discussion

there is no difference, the first is just a replacement of the last.  (see here)

I could assume that they just wanted to use the same keywords in different commands.

"trap-source" is very specific to snmp where as source-interface can generally be used like in

    logging source-interface ...

    cdp source-interface ...

4 REPLIES

Re: SNMP command discussion

there is no difference, the first is just a replacement of the last.  (see here)

I could assume that they just wanted to use the same keywords in different commands.

"trap-source" is very specific to snmp where as source-interface can generally be used like in

    logging source-interface ...

    cdp source-interface ...

SNMP command discussion

It certainly would make network management easier if we had consisted way to control what IP is used to send traps, SYSLOG and CDP messages.  I assume IOS 15 would have all that?

Cheers,

Michel

New Member

SNMP command discussion

dont know for 15 but they all exists on 12.4T

New Member

SNMP command discussion

very informitive and clear enough, thx Martin

438
Views
0
Helpful
4
Replies
CreatePlease login to create content