Channel group 40 LACP port Admin Oper Port Port Port Flags State Priority Key Key Number State Te5/4 SA bndl 32768 0x28 0x28 0x505 0x3D
Channel group 41 LACP port Admin Oper Port Port Port Flags State Priority Key Key Number State Gi7/42 SA bndl 32768 0x29 0x29 0x72B 0x3D Gi7/43 SA bndl 32768 0x29 0x1029 0x72C 0x3D Gi7/44 SA bndl 32768 0x29 0x1029 0x72D 0x3D
Well, you have a 6500, so depending on IOS, portOperStatus should give you the port status. The VLAN can be found in vmVlan. The port type can be found in portType (or from the entPhysicalTable in the ENTITY-MIB).
I don't have a switch with channels running LACP to confirm, but the SNMP support for LACP can be found in the IEEE8023-LAG-MIB and the CISCO-LAG-MIB. I suggest you try walking those to see what you can glean regarding your port channels.
The entries under entPhysicalDescr looks equivalent to the CLI "Type". Is there any better way to map these back to specific ifIndex entries, similar to what portIfIndex (11) of CISCO-STACK-MIB provides, or is correlating via entPhysicalName (7) <=> ifName (1)the only option I have?
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...