Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Snmp Error Message

Hello Every one

I have Problem Regarding my SNMP agent in cisco 6500 switch , the switch shows down on my cisco LMS server after deep investigation i found thos error messeage on my core switch

%SNMP-3-INPUT_QFULL_ERR: Packet dropped due to input queue full

1 REPLY
Cisco Employee

Snmp Error Message

Hi ,

SNMP-3-INPUT_QFULL_ERR:   can be because of multiple reasons like : Excessive SNMP polling .

check if they is any host polling this particular device very frequently or multiple host polling the same device at almost same interval.

One of the workaround is to create Access-list allowing SNMP traffic for particular hosts ONLY.

other workaround is below ( these are the most common OID's which can cause issue , you can restrict them from polling ):

you need to configure the SNMP VIEW as below:

snmp-server view cutdown iso included

snmp-server view cutdown at excluded

snmp-server view cutdown ip.21 excluded

snmp-server view cutdown ciscoMemoryPoolMIB excluded

snmp-server view cutdown ciscoEnhancedMemPoolMIB excluded

snmp-server view cutdown ciscoFlashMIB excluded

snmp-server community view cutdown RO

snmp-server community view cutdown RW

Thanks-

Afroz

[Do rate the helpful post]

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
283
Views
5
Helpful
1
Replies
CreatePlease to create content