i am a student doing my graduation project about networking, i also take CCNA semester 1 and 2,
i am preparing a web application for university's computer center, i need to open internet access for students in the dormitories, by combining their IP address and MAC address (forming an ARP Command), and sending this ARP command to the CISCO Router so they have access,
i am using asp.net2005 with c#,
i think i need to use SNMP,(wsnmp32.dll), to send the ARP command that are prepared already.
Can anybody help me,how to configure the Router, can i do this using only wsnmp32.dll ,about the programming part?
any document or link will help so much, thank for ur replies, have a nice day
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...