Please find a question and response I posted on the telephone netpro section. I now need a little help from you chaps in the infrastructure section.
My situation is this - I have a 2650XL VOIP router and need to monitor the DSP interfaces. Jo sent me details of a MIB that I need to complete my task.
We have Ciscoworks LMS3.0.1
I need to now how to install this mib onto my router and also I need to understand if Ciscoworks can be used to monitor the interface or do I need to do it from the command line?
Any help or guidance would be appreciated.
I need to figure out how many of our ports are being used daily on our ISDN PRI circuit. We have 25 channels active and my company I looking to add an additional 200 staff in the coming months. I need to determine if I have enough capactiy in the PRI.
Do you have the Health and Utilization Monitor add-on installed? This would be the only application within LMS into which MIBs can be loaded, and which can do this kind of polling. If you do, you can go to Admin > Load MIB, and load the CISCO-POP-MGMT-MIB. However, you will first need to go through the IMPORTS clause at the top of that MIB, and load all required dependencies.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.