Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP Link down trap test

Anyone have a good test to run to verify that SNMP Trap message is sent from router if T1 link goes down without actually having to shut it down? 2600 series 12.3x. 6500's show a test snmp command but that does not exist in the 2600 or 2800 I have tried on. Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: SNMP Link down trap test

There is no way to test this other than actually bringing a link down. We have an open enhancement request to add SNMP trap testing capabilities to IOS (CSCsb74381). IT will slowly be integrated into newer versions of IOS. The command will be "test snmp trap".

1 REPLY
Cisco Employee

Re: SNMP Link down trap test

There is no way to test this other than actually bringing a link down. We have an open enhancement request to add SNMP trap testing capabilities to IOS (CSCsb74381). IT will slowly be integrated into newer versions of IOS. The command will be "test snmp trap".

567
Views
5
Helpful
1
Replies