Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP MIB bug with Cisco 6500 running IOS

I noticed an SNMP MIB output discrepancy with Cisco 6500 running IOS

BOOTLDR: s72033_rp Software (s72033_rp-IPSERVICESK9-M), Version 12.2(18)SXF4, RELEASE SOFTWARE (fc1)

Basically, if I snmpwalk .1.3.6.1.2.1.2.2.1.2

I see my 137 interfaces on the switch. That being the case. I should see the output of walking .1.3.6.1.2.1.2.1.0 as 137. However, my output says 133. These MIBs match up perfectly on my other Cisco Switches. Is this a bug?

Attached is the output from my snmpwalk commands.

Thanks,

Danny

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: SNMP MIB bug with Cisco 6500 running IOS

Have a closer look at your snmpwalk...there are 133 interfaces on this device.

There are no interfaces .91, .111, .125, .135

This is fine too as these interfaces may have been deleted or removed.

2 REPLIES
Cisco Employee

Re: SNMP MIB bug with Cisco 6500 running IOS

Have a closer look at your snmpwalk...there are 133 interfaces on this device.

There are no interfaces .91, .111, .125, .135

This is fine too as these interfaces may have been deleted or removed.

New Member

Re: SNMP MIB bug with Cisco 6500 running IOS

Is it possible for .91, .111, .125, .135 to dissappear (ie. If I reboot the switch?)

Thanks,

-Danny

418
Views
0
Helpful
2
Replies
CreatePlease login to create content