cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1278
Views
0
Helpful
2
Replies

SNMP MIB bug with Cisco 6500 running IOS

loughlind
Level 1
Level 1

I noticed an SNMP MIB output discrepancy with Cisco 6500 running IOS

BOOTLDR: s72033_rp Software (s72033_rp-IPSERVICESK9-M), Version 12.2(18)SXF4, RELEASE SOFTWARE (fc1)

Basically, if I snmpwalk .1.3.6.1.2.1.2.2.1.2

I see my 137 interfaces on the switch. That being the case. I should see the output of walking .1.3.6.1.2.1.2.1.0 as 137. However, my output says 133. These MIBs match up perfectly on my other Cisco Switches. Is this a bug?

Attached is the output from my snmpwalk commands.

Thanks,

Danny

1 Accepted Solution

Accepted Solutions

David Stanford
Cisco Employee
Cisco Employee

Have a closer look at your snmpwalk...there are 133 interfaces on this device.

There are no interfaces .91, .111, .125, .135

This is fine too as these interfaces may have been deleted or removed.

View solution in original post

2 Replies 2

David Stanford
Cisco Employee
Cisco Employee

Have a closer look at your snmpwalk...there are 133 interfaces on this device.

There are no interfaces .91, .111, .125, .135

This is fine too as these interfaces may have been deleted or removed.

Is it possible for .91, .111, .125, .135 to dissappear (ie. If I reboot the switch?)

Thanks,

-Danny

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: