SNMP Mib OID

maryodriscoll · ‎09-01-2008

Hello,

I am receiving an OID alert in from some Cisco Metro 3750 switches. Summary of OID is 1.3.6.1.2.1.14.16.6.10. On the MIB tree, I get as far as 13.6.1.2.1.14 which is the OSPF tree but it only goes as far as 15 which is ospfConformance. Any ideas on how I can translate this OID?

Show ver

Metro_3750#sh ver

Cisco IOS Software, C3750ME Software (C3750ME-I5-M), Version 12.2(25)EY3, RELEASE SOFTWARE (fc1)

Compiled Fri 02-Sep-05 08:07 by myl

ROM: Bootstrap program is C3750 boot loader

BOOTLDR: C3750ME Boot Loader (C3750ME-HBOOT-M) Version 12.1(14r)AX, RELEASE SOFTWARE (fc1)

Metro_3750 uptime is 33 weeks, 3 days, 3 hours, 14 minutes

System returned to ROM by power-on

System restarted at 12:15:34 GMT Fri Jan 11 2008

System image file is "flash:c3750me-i5-mz.122-25.EY3/c3750me-i5-mz.122-25.EY3.bin"

cisco ME-C3750-24TE (PowerPC405) processor (revision E0) with 118784K/12280K bytes of memory.

Processor board ID CAT1010N11N

Last reset from power-on

1 Virtual Ethernet interface

24 FastEthernet interfaces

4 Gigabit Ethernet interfaces

The password-recovery mechanism is enabled.

1024K bytes of flash-simulated non-volatile configuration memory.

Base ethernet MAC Address : XXXXXXXXXXXXXXXXXXXXXXXXX

Motherboard assembly number : XXXXXXXXXXXXXXXXXXX

Motherboard serial number : CATXXXXXXXXXXXXXX

Model revision number : E0

Motherboard revision number : A0

Model number : ME-C3750-24TE-M

Daughterboard assembly number : XXXXXXXXXXXXXXXXXXXX

Daughterboard serial number : CATXXXXXXXXXXXXXXXXXXX

Daughterboard revision number : A0

System serial number : CATXXXXXXXXXXXXXXX

Top Assembly Part Number : XXXXXXXXXXXXXXXXX

Top Assembly Revision Number : B0

Version ID : V05

CLEI Code Number :XXXXXXXXXXXX

Daughterboard revision number : A0

Hardware Board Revision Number : 0x09

Switch Ports Model SW Version SW Image

------ ----- ----- ---------- ----------

* 1 28 ME-C3750-24TE 12.2(25)EY3 C3750ME-I5-M

Configuration register is 0xF

Regards

Mary

Joe Clarke · ‎09-01-2008

I'd have to see the raw trap PDU to be sure, but I'm guessing this is your application's way of saying this is an OSPF trap of general type 6 (enterprise-specific) and specific type 10 which would be ospfTxRetransmit:

ospfTxRetransmit NOTIFICATION-TYPE

OBJECTS {

ospfRouterId, -- The originator of the trap

ospfIfIpAddress,

ospfAddressLessIf,

ospfNbrRtrId, -- Destination

ospfPacketType,

ospfLsdbType,

ospfLsdbLsid,

ospfLsdbRouterId

}

STATUS current

DESCRIPTION

"An ospfTxRetransmit trap signifies than an

OSPF packet has been retransmitted on a non-

virtual interface. All packets that may be re-

transmitted are associated with an LSDB entry.

The LS type, LS ID, and Router ID are used to

identify the LSDB entry."

::= { ospfTraps 10 }

maryodriscoll · ‎09-02-2008

Ok, that is helpful. What we are receiving is the trap below. OspfTXRetransmits though -

should that be something I worry about as they are occuring very often(or rather the trap is logged often)?

SNMP config on the Metro Switch is as follows:

snmp-server enable traps ospf state-change

snmp-server enable traps ospf errors

snmp-server enable traps ospf retransmit

snmp-server enable traps ospf lsa

snmp-server enable traps ospf cisco-specific state-change

snmp-server enable traps ospf cisco-specific errors

snmp-server enable traps ospf cisco-specific retransmit

snmp-server enable traps ospf cisco-specific lsa

Node AlertKey Summary Manager LastOccurrence Count

Metro_3750 .1.3.6.1.2.1.14.16 6 10 XXXXXXXXXXXXXXXXXXX 02/09/08 10:24:39 439

Joe Clarke · ‎09-02-2008

You may want to ask this on the routing protocols forum.