Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP NOT RESPOND

Recently I installed CiscoWorks 2000, but right now I have a problem:

1 - Most of my Routers and Switch they have protocol SSH, and the other telnet. 2 - CiscoWorks added in its base of data to the equipment, registers it like Manage, but it says that they do not respond to SNMP.

How I can solve this?

1 REPLY
Cisco Employee

Re: SNMP NOT RESPOND

Re-enter the SNMP credentials under RME > Administration > Inventory > Change device attributes after confirming the correct values on the devices that are not responding.

If the strings are known to be correct, check that there is not a firewall or a device with access-lists that are preventing the CiscoWorks server from communicating via SNMP with these devices (SNMP uses UDP port 161).

92
Views
0
Helpful
1
Replies