Problem number 2 is that whenever I reboot the switch, the remote user definitions disappear. This happens on two different platforms/IOS versions (3560 12.2(55)SE5 and 2960 15.0(2)SE4) otherwise I'd chalk it up to a regression. It also happens no matter how much I try to downgrade the auth/priv level -- even to v2c user definitions. Before the reboot the users are listed as stored in nonvolatile, just like all the local users.
Can anyone spot any missing components from this config? Has anyone else seen the lost snmp user entries behavior?
Yay... finally figured out a workaround for this one. If you add a local snmp user with the same name and parameters as the remote SNMP user, then everything suddenly works. A clue if you are having this problem is that when you list snmp users after adding the remote user, it does not show a Group-name for the user. After adding the local user, it shows a Group-name, informs get sent (using the remote user/engineID no less!) and the switch remembers both users after a reboot.
Probably more people haven't noticed this problem because they configure the local user first before they realize they need to configure a remote user after consulting the docs, and do not delete the local user.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.