Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP OID for active voice calls

I have been trying to search for the correct SNMP OID / MIB to retrieve actual "active voice calls' on cisco router 2911 version 15.2(4)M5

 

We need to confirm if calls volume is exceeding contracted limit with ISP ( AT&T), causing call drops.

 

Thanks in advanced for your help

 

Enrique

 

4 REPLIES
Cisco Employee

Hi Enrique,I believe that the

Hi Enrique,


I believe that the OID you are looking for is cpmActiveDS0s (OID -
1.3.6.1.4.1.9.10.19.1.1.4) part of CISCO-POP-MGMT-MIB. This object provides the number of
DS0s that are currently in use.

if you don't see the expected result, you may also try to use cvCallActiveDS0s (OID -
1.3.6.1.4.1.9.9.63.1.3.3) which is part of CISCO-VOICE-DIAL-CONTROL-MIB

 

other related OID's are :


Object: callActiveTable

OID: 1.3.6.1.2.1.10.21.1.3.1

Description: "A table containing information about active calls to a
specific destination."

 

Object: callActiveCallState  

OID 1.3.6.1.2.1.10.21.1.3.1.1.9

Description "The current call state.
unknown(1) - The call state is unknown.
connecting(2) - A connection attempt (outgoing call) is being made.
connected(3) - An incoming call is in the process of validation.
active(4) - The call is active.

 

Object: cvCallActiveDS0s

 OID: 1.3.6.1.4.1.9.9.63.1.3.3

Description "The current number of DS0 interfaces used for the  active
calls."

 

Thanks-

Afroz

***Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Afroz thanks a lot for your

Afroz thanks a lot for your answer, these commands apply to CUBE router too, where we have a SIP trunk to ISP??

Thanks ia advanced for your answer

Cisco Employee

yes , OID's should be same.

yes , OID's should be same. they should work fine

 

 

Thanks-

Afroz

***Ratings Encourages Contributors ***

Thanks- Afroz [Do rate the useful post] ****Ratings Encourages Contributors ****
New Member

Afroz....THANKS a lot for

Afroz....

THANKS a lot for your help !!!

1047
Views
5
Helpful
4
Replies