Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP OID traffic engineering link metric

Hello,

does Cisco implement some OID to get traffic engineering (te) metric of the link when using MPLS TE? I need actually to write this parameter over SNMP so i need to find an OID through which i get/set this parameter of link. I was looking for it in OSPF-MIB and MPLS-TE-MIB but found nothing yet.

Thanks.

Jakub

1 REPLY
Cisco Employee

The MIBs under considerations

The MIBs under considerations should be ‘MPLS-TE-STD-MIB’ and ‘MPLS-TE-MIB’.

MPLS TE doesn't have a strong implementation and hence you need to describe what output you're looking in terms of cli equivalent command.

Please check this document which should be helpful :

http://www.cisco.com/c/en/us/td/docs/ios/12_0s/feature/guide/te_mib17.html

If you are refferring to output of show mpls traffic-eng tunnels, than you can check :

mplsTunnelResourceMaxRate which shows the maximum rate in bits/second.

Also, you can check 'ifSpeed' gives the tunnel's bandwidth but not the configured value of the TE tunnel.

-Thanks

Vinod

** Encourage Contributors. RATE Them**

-Thanks Vinod **Rating Encourages contributors, and its really free. **
61
Views
0
Helpful
1
Replies
CreatePlease login to create content