Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP Polling to Loopback Interface for Avaliability stats

Router 7606.

IOS: 12.2(33)SRE1, or 15.0(1)S1.

Can we use CA's eHealth performance monitor to poll the loopback int for avaliability stats?  is the loopback interface part of 'interface' mib and does it responds to stats like up/down or avaliabilty etc .

Thanks much.

1 REPLY
Cisco Employee

Re: SNMP Polling to Loopback Interface for Avaliability stats

hi Atef,

the loopback interface is a part of the interfaces in the if-mib.

so if you do snmpwalk on the ifEntry you will see the interface loopback listed there and the status of the (oper and admin status) will be shown.

hope this helps.

596
Views
5
Helpful
1
Replies
CreatePlease to create content