We have a CAT 4510R running IOS 12.2(25)EW . We do not get a response from a SNMP QUERY to one of the IPv6 addresses on the Switch. The config for SNMP-SERVER community does not have an IPv6 parm. When will this be supported? I looked at the doc for IOS 12.2(31) . I can not find a SNMP-SERVER COMMUNITY configuration cmd. How can I code a community name with 12.2(31) ?
SNMP over IPv6 is not currently supported on the Cat4500 series. It is planned for a future release, but I do not know the time table as to when that release will be available. Currently, the only switches to support SNMP over IPv6 are Cat6500s running 12.2(33)SRB code.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...