Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

snmp setting =notifyview=

Hi Experts,

I am replacing switch from WS-C2960(Switch names are A-1) into WS-C2960XR(Switch names are A-2), the new switches will take over configuration from current switches WS-C2960.

I loaded command "snmp-server group Mongroup v3 auth notify *tv.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF0F access ALC_A" which is from current configuration of A-1 into new Switch A-2, but the show run of A-2 displays as below. It doesn't show notifiy view.

---------------------------------------------------------

snmp-server group Monadmin v3 auth
snmp-server group Mongroup v3 auth access ALC_A

---------------------------------------------------------

The "show run all" of A-2 displays as below.

---------------------------------------------------------

snmp-server group Monadmin v3 auth match exact notify *tv.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF7F
snmp-server group Mongroup v3 auth match exact read v1default access ALC_A
snmp-server view v1default iso included
snmp-server view v1default internet included
snmp-server view v1default snmpUsmMIB excluded
snmp-server view v1default snmpVacmMIB excluded
snmp-server view v1default snmpCommunityMIB excluded
snmp-server view v1default ciscoMgmt.252 excluded
snmp-server view *tv.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF7F iso included
snmp-server view *tv.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF7F iso.2.840.10036 included

---------------------------------------------------------

The notifyview looks different from the command from current switch A-1.

So this command "snmp-server group Mongroup v3 auth notify *tv.FFFFFFFF.FFFFFFFF.FFFFFFFF.FFFFFFFF0F access ALC_A" is not applied to new switch properly? In order to load this settings into new switch, what can I do?

The IOS version of current switches is 12.2, the one of new switches is 15.2.

Any advice will be deeply appreciated.

Best regards,

19
Views
0
Helpful
0
Replies
CreatePlease login to create content