Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP to get switch bandwidth

I have a Catalyst 2955 and i cant seem to find a way to get the switchport bandwidth using SNMP OIDs values. How can i do this calculation?

4 REPLIES
Blue

Re: SNMP to get switch bandwidth

Have you looked at CISCO-C2900-MIB for this?

New Member

Re: SNMP to get switch bandwidth

using c2900BandwidthUsageCurrent im able to get the overall bandwidth of the entire switch, im interested in getting the individual bandwidth for each port, thanks for the previous advice though

New Member

Re: SNMP to get switch bandwidth

Are you enable http service in the switch? they has the utility to view many options, like bandwidth, vlan, status.

Exist another utility to view bandwidth. try this one.

http://www.paessler.com/ "Excellent software"

New Member

Re: SNMP to get switch bandwidth

I use a program called cacti, it runs on linux and is open source. I think you should give it a shot... The PRTG program that the other user gave is a good one too but this is open source and wont bog your box down, I am watching 300+ devices and the box isnt breaking a sweat.

http://www.cacti.net/

HTH, if so pls rate..

165
Views
0
Helpful
4
Replies