SNMP to get switch bandwidth

julianelizondo · ‎03-21-2006

I have a Catalyst 2955 and i cant seem to find a way to get the switchport bandwidth using SNMP OIDs values. How can i do this calculation?

rmushtaq · ‎03-21-2006

Have you looked at CISCO-C2900-MIB for this?

julianelizondo · ‎03-21-2006

using c2900BandwidthUsageCurrent im able to get the overall bandwidth of the entire switch, im interested in getting the individual bandwidth for each port, thanks for the previous advice though

jcbuilder · ‎03-22-2006

Are you enable http service in the switch? they has the utility to view many options, like bandwidth, vlan, status.

Exist another utility to view bandwidth. try this one.

http://www.paessler.com/ "Excellent software"

WAYNE MOORE · ‎03-23-2006

I use a program called cacti, it runs on linux and is open source. I think you should give it a shot... The PRTG program that the other user gave is a good one too but this is open source and wont bog your box down, I am watching 300+ devices and the box isnt breaking a sweat.

http://www.cacti.net/

HTH, if so pls rate..