I would like to enable snmp traps on my CatOS and IOS switches. Specifically, I would like to receive notifications on the following:
Power supply failure
Line card failure on chassis
Uplink failures (regardless of interface type)
I understand I should use the command snmp-server enable traps IOS. If so, I see that power supply traps can be sent with the envmon keyword. I also see that interface traps can be sent with the SNMP keyword. Is this correct and can I configure that for specific interfaces and not all of the ports/interfaces on a device
How can the line card failure traps be configured and how can all these be setup on CATOS?
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.